my project

this is a 42% reduction pulley for my crank shaft, ill be putting this on in the next few days hopefully

ive got the back seat tore out and the car up on jack stands, doors panels are off too and getting ready to take off the rims and tires so that i can get my bullit rims.....275/45/17 in fronts and 315/45/17 in the back ....im going to have ultra traction haha

just orderer port and polished heads, p&p upper and lower intakes, roller rockers, springs, arp studs, and next ill need a good cam this should all give me about a 50-60rwhp gain im hoping then comes the full exhaust LT headers with an H pipe and flowmaster 40s im excited

I have an Entire cat back with Flow 40's in it that I just pulled off my car. It's not pretty but it is functional.

Nice progress!

out of curiosity why are the seats and door panels pulled?

the door panels were taken off so that i can fix my drivers door window, it wont go down something with the track........and i am going to put new door speakers in too
and as for the rear seat ....im deleting it and making a custom back seat........ill be putting a subwoofer in their once i fiberglass a box for it itll look pretty cool i got as far as taking it all out and putting in the power cable for my amp

if you check the the windows have a piece that is bonded to them, that hooks them to the track and it is pretty common for this piece to break loose and then you need a new window (already been through this one)

yea a week before i bought the car they had the same window replaced but i did not know why, it must have broken again thanks for the help.....oh how much did it cost to get it replaced

um if you go through a dealer its like $400 but i got one through a junk yard for like $70

for the window and work? or just the window/glass?

I am sure that is the glass price only.

yeah that was for new glass and track was like $430 not including labor

geez! thats expensive...would it be easy to replace myself? im pretty mechanically inclined ......

really easy to replace just a couple pop rivets... or if you don't want to bother with it you can buy the window used at a salvage yard and pay a local glass company to put it in (cheaper than the dealership)

well i just ordered ported and polished heads, p&p upper and lower intakes, new springs and pushrods, new valves............i will be ordereing 1.73 rockers really soon with an intake spacer and some long tube headers

oh and i just spent over $100 on gaskets lol dam they are expensive
once this snow goes away ill be able to get a lot of work done