Single Turbo v6 Tuning Session!

Alright folks i sealed my fate tonight by ordering my SCT Xcal3 and the PRP tuning software! wish me luck on tuning this thing (15-20psi looking for 500-600rwhp)

let me know when bro...u got my digits

You know I'm there!

im always down i read some of that bible

Xcal will be here this week! time to see if the car starts !!

i will keep u in my prayers!!! im sure it will go just fine

remember ur turbo pipes r loose and ur battery is probably dead

COLE wrote:remember ur turbo pipes r loose and ur battery is probably dead

small details, lets finish this thing

Its finally here !!



the challenge begins

OH SNAP!

loaded the tune in today and guess what! car starts but my MAF voltage says invalid ! so know i need to double check the wiring now

dude its probably those two wires that justin said went one way but alldata said went the other definately switch those and you should be good to go

ill try but i was putting my money on that also

Ditto. The 05-09 V6 & V8 have some weird feeds in the MAF including temp, barometer, air flow, air density, and even moisture.

Thanks goes out to J for making it over and helping with the tune yesterday.... I finished the lower RPM tune which is .02 of a % off of perfect the upper RPM pulls will just be modifing the maf transfer function table to get the A/F correct under boost, i called RPM transmissions in anderson as the owner stated i can use his dyno for free after hours to get my car dialed in !!!!!! I cant wait to get this thing finished

changed the Fuel injector high/low slope and changed the base fuel table the STFT is dead on 100% from 2000-3000 but i need to change the 1000-1500 values now but those are only rich by 2% over lamda I will adjust that tonight and load it into the car tomorrow to see the transformation