WILDHORSES MUSTANG CLUB
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Pull it out

2 posters

Go down

Pull it out Empty Pull it out

Post by Guest Thu Feb 03, 2011 3:33 pm

Looking into having someone pull the 4.6 motor of my '97 Mustang. Half the forums say to drop the K member and go out the bottom, the other half say you can pull it out the top. Ideas, suggestions? I do have someone lined up to rebuild the motor once it's pulled out.

Guest
Guest


Back to top Go down

Pull it out Empty Re: Pull it out

Post by BRADTHEBLADE Thu Feb 03, 2011 4:05 pm

i find it way easier to pull motor and trans out the top as one unit.i have done more than i care to count.but again this is just my2cents
BRADTHEBLADE
BRADTHEBLADE
Small Block 302
Small Block 302

Male Number of posts : 380
Age : 49
My Name: : Brad
My Ride/Rides: : mine 95vert/wife 01 gt
Mods: : custom paint v6 to v8 swap auto to tko 500 swap 7.5 to cobra irs swap all locks and antenna shaved lowerd 2.5 inches red interior swaped to all black cobra interior powder coated engine parts svo side exhaust one piece NON halo head lights clear tail lights and side markers saleen speedster cover 10.5 chrome cobra r rims out back and 9,s up front 3.73 gears aluminum radiator and drive shaft 125 shot dual nitrous tank set up style bar with custom air defuzer and alot of other things i forget

Back to top Go down

Pull it out Empty Re: Pull it out

Post by BraMas Thu Feb 03, 2011 9:25 pm

I agree with Brad on pulling the engine and trans out the top. If I had a lift I could see where dropping the k-member way could be easier.
BraMas
BraMas
Admin

Male Number of posts : 1533
Age : 100
My Name: : Tim

Back to top Go down

Pull it out Empty Re: Pull it out

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum